CORROSION BEHAVIOR OF MILD STEEL IN SODIUM SULFATE SOLUTION IN PRESENCE OF PHOSPHATES OF DIFFERENT COMPOSITION

2024

Full text Open access: Gold Metadata (CSL-JSON)
DOI 10.59957/jctm.v59.i2.2024.16
Data confidence 70 medium
How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

Corrosion of mild steel in sodium sulfate solutions (1000 mg SO42- L-1) in the presence of various phosphateinhibitors was studied gravimetrically. Studies were performed under static conditions at room temperature. The known sodium polyphosphate inhibitor has been found to have low efficacy under these conditions. The inhibitor efficiency of its does not exceed 30.5 % at a concentration of 100 mg P2O5 L-1. It has been shown that a more effective inhibitor is calcium-manganese polyphosphate (Са, Mn)(PO3)2 obtained on the basis of manganese ore enrichment wastes of the Zhayrem deposit. The inhibitor efficiency of its already at a concentration of 20 mgP2O5 L-1 is 47.3 %. At a concentration of 100 mgP2O5 L-1, the inhibitor efficiency (Са, Mn)(PO3)2 is 96.2 %. Electrochemical tests confirmed the results of the gravimetric study. Infrared spectroscopic analysis showed that phosphate protective coatings were formed on the steel surface in solutions of sodium sulfate with additives of calcium-manganese polyphosphate.