CORROSION BEHAVIOR OF MILD STEEL IN SODIUM SULFATE SOLUTION IN PRESENCE OF PHOSPHATES OF DIFFERENT COMPOSITION

2024

Полный текст Открытый доступ: Gold Метаданные (CSL-JSON)
DOI 10.59957/jctm.v59.i2.2024.16
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

Corrosion of mild steel in sodium sulfate solutions (1000 mg SO42- L-1) in the presence of various phosphateinhibitors was studied gravimetrically. Studies were performed under static conditions at room temperature. The known sodium polyphosphate inhibitor has been found to have low efficacy under these conditions. The inhibitor efficiency of its does not exceed 30.5 % at a concentration of 100 mg P2O5 L-1. It has been shown that a more effective inhibitor is calcium-manganese polyphosphate (Са, Mn)(PO3)2 obtained on the basis of manganese ore enrichment wastes of the Zhayrem deposit. The inhibitor efficiency of its already at a concentration of 20 mgP2O5 L-1 is 47.3 %. At a concentration of 100 mgP2O5 L-1, the inhibitor efficiency (Са, Mn)(PO3)2 is 96.2 %. Electrochemical tests confirmed the results of the gravimetric study. Infrared spectroscopic analysis showed that phosphate protective coatings were formed on the steel surface in solutions of sodium sulfate with additives of calcium-manganese polyphosphate.