Discharge Initiation in Globus-M2 and KTM Tokamaks Using a Coaxial Plasma Jet Accelerator

2021

Closed access Metadata (CSL-JSON)
DOI 10.1134/s1063780x21080109
Data confidence 70 medium
How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

Abstract Studies were performed on the possibility of using the coaxial plasma jet accelerator to facilitate breakdown and the plasma current start-up in the Globus-M2 and KTM tokamaks. The results of experiments on the jet injection into the Globus-M2 tokamak with a magnetic field of 0.7 T showed that the discharge current rise began 1–2 ms earlier than it did in experiments using gas puffing and inductive breakdown of the working gas. In this case, the breakdown voltage decreased approximately 2 times. The results of experiments on plasma jet injection through the equatorial diagnostic duct into the KTM tokamak with a magnetic field of 0.9 T showed that the gas breakdown occurred up to 6 ms earlier than the breakdown initiated using the inductive method. In this case, the loop voltage decreases approximately 1.5 times. In almost all shots using the accelerator, the gas breakdown occurred, while in its absence, sometimes the gas breakdown could not be obtained.