Discharge Initiation in Globus-M2 and KTM Tokamaks Using a Coaxial Plasma Jet Accelerator

2021

Закрытый доступ Метаданные (CSL-JSON)
DOI 10.1134/s1063780x21080109
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

Abstract Studies were performed on the possibility of using the coaxial plasma jet accelerator to facilitate breakdown and the plasma current start-up in the Globus-M2 and KTM tokamaks. The results of experiments on the jet injection into the Globus-M2 tokamak with a magnetic field of 0.7 T showed that the discharge current rise began 1–2 ms earlier than it did in experiments using gas puffing and inductive breakdown of the working gas. In this case, the breakdown voltage decreased approximately 2 times. The results of experiments on plasma jet injection through the equatorial diagnostic duct into the KTM tokamak with a magnetic field of 0.9 T showed that the gas breakdown occurred up to 6 ms earlier than the breakdown initiated using the inductive method. In this case, the loop voltage decreases approximately 1.5 times. In almost all shots using the accelerator, the gas breakdown occurred, while in its absence, sometimes the gas breakdown could not be obtained.