3D modelling and evaluation of parietal flow features in the nasal cavity

2022

Closed access Metadata (CSL-JSON)
DOI 10.1117/12.2660669
Data confidence 85 high
How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

In the evidence-based diagnosis of nasal breathing disorders and the planning of corrective surgical procedures, it is not sufficient to examine only the general characteristics of airflow - averaged values of aerodynamic parameters such as airflow rate, pressure drop, and aerodynamic nasal resistance. It is necessary to investigate the effect of airflow on the mucosa at the micro level, which, when pathological conditions develop, leads to excessive drying of the nasal cavity surface. To do this, it is necessary to compare the width of the laminar boundary layer – the parietal region, where the maximum change in airflow velocity is observed, and the height of the nasal mucosa irregularity. The calculated values of the laminar airflow boundary layer were obtained from model representations of the complex spatial configuration of the nasal cavity using a circular channel of equivalent diameter.