3D modelling and evaluation of parietal flow features in the nasal cavity

2022

Закрытый доступ Метаданные (CSL-JSON)
DOI 10.1117/12.2660669
Достоверность данных 85 высокая
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

In the evidence-based diagnosis of nasal breathing disorders and the planning of corrective surgical procedures, it is not sufficient to examine only the general characteristics of airflow - averaged values of aerodynamic parameters such as airflow rate, pressure drop, and aerodynamic nasal resistance. It is necessary to investigate the effect of airflow on the mucosa at the micro level, which, when pathological conditions develop, leads to excessive drying of the nasal cavity surface. To do this, it is necessary to compare the width of the laminar boundary layer – the parietal region, where the maximum change in airflow velocity is observed, and the height of the nasal mucosa irregularity. The calculated values of the laminar airflow boundary layer were obtained from model representations of the complex spatial configuration of the nasal cavity using a circular channel of equivalent diameter.