InGaAsP-InP ridge-waveguide DBR lasers with first-order surface gratings fabricated using CAIBE

Robert M. Lammert, A.M. Jones, Chris Youtsey, J.S. Hughes, S.D. Roh, I. Adesida, J. J. Coleman

1997

Closed access Metadata (CSL-JSON)
DOI 10.1109/68.634703
Data confidence 70 medium
How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

The design and operation of InGaAsP-InP ridge-waveguide (RW) distributed Bragg reflector (DBR) multiple quantum-well lasers with first-order surface gratings are presented. The RW DBR lasers are fabricated using only a single growth step without growth on a corrugated surface. Uncoated devices with grating etch depths of 0.6 and 0.5-μm exhibit pulsed threshold currents of 32 and 43 mA with slope efficiencies of 0.34 and 0.24 W/A, respectively. The device with a grating etch depth of 0.5-μm operates on a single longitudinal mode with about 40 dB side-mode suppression. All these results are from devices with Bragg condition wavelengths which are red-shifted from the peak spontaneous emission wavelength by over 400 /spl Aring/.