Creating cdte nanoclusters in SiO2/Si track templates with the use of two electrolyte types

2019

Закрытый доступ Метаданные (CSL-JSON)
DOI 10.1063/1.5134157
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

This paper presents the results of the study of CdTe nanoclusters prepared by electrochemical deposition using sulphate and chloride solutions. The SiO2/Si track templates were used as nanoporous templates. The а-SiO2/Si-n track template was obtained by irradiation with xenon ions with an energy of 200 MeV, with fluences of 107–108 ions/cm2. The surface of the deposited samples was examined using scanning electron microscopy. To identify the crystal structure of CdTe nanoclusters, an X-ray structural analysis was carried out to form cadmium telluride nanocrystals of the hexagonal phase (wurtzite) together with the amorphous phase. Calculations of crystallite sizes showed that annealing CdTe samples at 100°C leads to changes in nanocrystallites and to increase in the degree of crystallinity with the dominance of the amorphous phase.