The Effect of Different Oxidants on Extraction of Uranium from Low Grade Ore

2020

Закрытый доступ Метаданные (CSL-JSON)
DOI 10.4028/www.scientific.net/ssp.299.1104
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

The effect of different oxidants on extraction of uranium from low grade ore was studied. Leaching was performed using sulfuric acid solutions at a concentration of 10 to 30%. Ferric sulfate Fe2(SO4)3, ammonium persulphate (NH4)2S2O8, and potassium permanganate KMnO4 at different concentrations were used as oxidants in different variants of the experiment. In addition, solutions collected at Vostok deposit containing 6.86 g/L Fe3+ and 106 cells/mL of the bacteria Acidithiobacillusferrooxidans were used for leaching. The rate of uranium extraction with sulfuric acid solutions without oxidants was low and did not exceed 19.4%. Addition of oxidants made it possible to increase rate of uranium extraction. In the presence of ferric sulfate, ammonium persulphate, and potassium permanganate rates of uranium extraction were up to 68, 95.2, and 69.6%, respectively. The rate of uranium leaching in the experiments with the AMD sample was high and reached about 95%. Therefore, it can be concluded that using not only oxidizing agents, but AMD, which are formed during the natural oxidation of sulfide minerals contained in the ore of the deposit, can significantly increase the rate of uranium recovery.