Exhaust waste heat recovery system using thermoelectric generator: a prospective of novel simulation technique toward low-carbon technology

Marzhan M Kubenova, Kairat A. Kuterbekov, Kenzhebatyr Zh. Bekmyrza, Asset Kabyshev, Gaukhar D. Kabdrakhimova, Farruh Atamurotov, Wubshet Ibrahim

International Journal of Low-Carbon Technologies, 2025

Full text Open access: Gold Metadata (CSL-JSON)

DOI 10.1093/ijlct/ctae249

Data confidence 85 high

How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

Abstract This study numerically optimizes energy harnessing in vehicle engines using three heat exchanger fin designs: wall to wall, pyramid, and hexagonal. Two thermoelectric generator (TEG) array configurations are compared for electrical power generation. Results show the wall-to-wall fin provides the highest heat transfer, producing 161 W of power from 13 590.53 W of heat. Both TEG configurations generate similar output, with the series offering slightly higher voltage. The flow direction has minimal impact, but increasing the number of heat exchangers boosts efficiency. The total system output reaches 27 763.60 W with a four-parallel exchanger setup and an efficiency of 1.72.