Abstract
In recent years, severe plastic deformation has been one of the most popular methods of increasing the mechanical properties of bars. Obtaining an ultra or nanostructure in such bars provides high strength properties, but also reduces plasticity. This paper shows that gradient structure formation in carbon steel bars gives a simultaneous increase in strength properties and some decrease in plastic properties. A new combined technology is proposed for obtaining gradient microstructure. This technology consists of drawing medium carbon steel bars on a radial-shear broaching mill and subsequent drawing. Bars with 30 mm diameter were strained at room temperature to a diameter of 16 mm in 3 passes. As a result, during three straining cycles, the average value of microhardness in the central zone was 2085 MPa, in the neutral zone was 2505 MPa, and in the surface zone was 2915 MPa. This variation of microhardness confirms gradient microstructure availability. Also there was an increase in strength characteristics almost 2 times, plastic characteristics undergo reduction due to gradient microstructure obtained during straining, but remain at a fairly good level for steel AISI 1045. The validity of the results is confirmed by a large number of experiments using a set of standard and modern research methods, such as optical, scanning and transmission microscopy, EBSD analysis, microhardness changes, fractographic method and tensile tests of mechanical properties, as well as by the results reproduction in the joint use of methods.