Measuring the self-generated magnetic field and the velocity of plasma flow in a pulsed plasma accelerator

Recent Contributions to Physics, 2021

Full text Open access: Gold Metadata (CSL-JSON)
DOI 10.26577/rcph.2021.v77.i2.04
Data confidence 70 medium
How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

In phase of radial compression the unsteady plasma flow at the exit of a pulsed plasma accelerators is related to the generation of fast high-energy charged particle beams, to plasma density perturbations, to the internal plasma pressure is opposite to the external magnetic pressure (B2/2μ0) associated with plasma column’s self-generated magnetic field. The last one listed above is of particular interest. The investigation of the magnetic field of plasma flow relatively gives information about the above mutually close factors cause to plasma flow instability.In this paper a miniature high-frequency magnetic probe are made for measuring and further investigating the pulsed self-generated magnetic field of plasma flow, in particular, at the exit of the accelerator in an experimental setup of PPA (located in KazNU, IETP). The magnetic probe dimensions are following: coil diameter is 2,12 mm, number of turns is 7, copper wire diameter is 150 μm, and winding length is 1, 1 mm. The coil inductance is about 0,113 μH and the temporal resolution of the magnetic probe is 2,3 ns. The magnetic probe was calibrated using a Hall sensor on the magnetic field of a multi-layered solenoid connected to an alternating power source of 15 A. Thus, the evaluated measurement error of the probe was no more than 10%.