Characterisation of the microplasma spraying of biocompatible coating of titanium

Darya L. Alontseva, Elaheh Ghassemieh, Sergii Voinarovych, Alyona V. Russakova, Oleksandr Kyslytsia, Yevhen Polovetskyi, A. TOXANBAYEVA

2019

Closed access Metadata (CSL-JSON)

DOI 10.1111/jmi.12849

Data confidence 85 high

How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

This paper presents new results of studying the influence of parameters of microplasma spraying (MPS) of Ti wire on the structure and properties of Ti coatings. Based on the design of the experiment and the results of the SEM study, certain spraying modes were chosen to form the desired composition and structure of the Ti coating. The dense sublayer (up to 300 µm thick) provides good adhesion to the substrate, and a porous top layer can accelerate the coated implant ingrowth with the bone. This technology is developed for the manufacture of coated endoprosthesis implants.