Analysis of methods for heating the lining of high-temperature aggregates

Е. В. Приходько

2021

Full text Open access: Hybrid Metadata (CSL-JSON)

DOI 10.17073/1683-4518-2021-8-40-44

Data confidence 70 medium

How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

An analysis of the methods of increasing the temperature of the lining during its drying and heating is given. Three options for increasing the temperature are considered: the maximum possible heating rate at first and its further decrease, the average heating rate, and the minimum heating rate at first and further acceleration to the maximum. It is shown that in order to preserve the resulting temperature stresses, no higher than the strength limit of the material is more efficient, the heating option with the highest possible speed first and its further decline. Ill. 4. Ref. 11.