OBTAINING CARBON FIBERS BASED ON COAL TAR BY ELECTROSPINNING METHOD

2021

Closed access Metadata (CSL-JSON)
DOI 10.51580/2021-1/2710-1185.16
Data confidence 85 high
How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

This research discusses the use of coal-processing wastes of the Shubarkol Deposit (Karaganda region, Kazakhstan) to produce valuable materials such as carbon fibers. Annually «Shubarkol Komir» JSC alone produces up to 35,000 tons of coal tar as byproduct. In this experiment, mesophase pitch was obtained by coal tar heat treatment at 200 o C. By cracking mesophase pitch into the pieces with the addition of poly (methyl methacrylate) as fiber-forming material and 1,2-dichloroethane as solvent, the spinnable solution was prepared. The elemental analysis of the mesophase pitch showed that the heat treatment up to 200 o C does not contribute to the full elimination of sulfur containing components that influence the forming of mesophase. From the Raman spectra of the pitch, the D peak appearance at ~ 1370 cm-1 and G peak at ~ 1600 cm-1 responsible for carbon products. Carbon fibers with an average diameter of 2.5-3.3 μm were obtained by electrospinning technique in laboratory settings.