GEOMECHANICAL MODELING OF STRUCTURES OIL AND GAS FIELDS

2021

Closed access Metadata (CSL-JSON)
DOI 10.32014/2021.2518-170x.60
Data confidence 70 medium
How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

The presence of areas of accumulation of hydrocarbons in the sedimentary strata is genetically related both to the conditions of sedimentation and to secondary changes in the properties of the geological environment, caused along with other and geodynamic processes. At the same time, it is the stress-strain state that is the key characteristic of the environment, the analysis of which makes it possible to predict the influence of geodynamic factors that cause deformation processes in the sedimentary stratum, on the formation of zones of decompaction and increased fracturing, areas of increased filtration-capacity properties of reservoir rocks, the direction of natural migration of hydrocarbons. Using the example of 3D seismic data obtained at the Akshabulak area, the possibility of integrating geomechanical modeling and additional express analysis of seismic data in solving problems related to determining the probable places of accumulations and directions of natural migration of hydrocarbons is shown.