Analysis of the Stress-Strain State of the Surfaced Tooth in the T-FLEX CAD Application Program

Toty Meirbekovna Buzauova, D. A. Sarbayev, Baglan Smailova, Shamshygaiyn Bolatkyzy Toleubayeva

2024

DOI 10.52209/2706-977x_2024_3_17

Data confidence 70 medium

How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

This work is devoted to the analysis of the stress-strain state of the surfaced gear teeth using the T-Flex CAD software. The study showed that the surfaced teeth are able to withstand workloads, as well as loads increased by 50%, demonstrating a deformation of only 2%. Zones of maximum stresses and deformations have been identified, which makes it possible to predict the durability and reliability of the surfaced teeth. The conducted studies confirm the effectiveness of the electroslag surfacing method for restoring gears and its application to improve the performance of gears under high loads