Proton beam energy calibration of the 3 MV Tandetron™ at IFIN-HH

2025

Full text Open access: Hybrid Metadata (CSL-JSON)
DOI 10.1088/1748-0221/20/07/p07051
Data confidence 85 high
How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

Abstract The ELIGANT-TN long neutron counter, the ELISSA silicon strip array and the Mini-eTPC active gas target detector all represent nuclear physics research tools constructed at Extreme Light Infrastructure - Nuclear Physics (ELI-NP) for use in γ-beam experiments. Currently, these three setups are used at the charged particle accelerators of the “Horia Hulubei” National Institute for R&D in Physics and Nuclear Engineering (IFIN-HH), for performing reaction cross-section measurements. Accurate knowledge of the incident beam energy is of paramount importance for such studies, which is why in the present article we report on a new proton beam energy calibration performed using the following threshold reactions: ^7Li(p,n)^7Be, ^13C(p,n)^13N and ^51V(p,n)^51Cr. The measurements were performed by varying the projectile energy across the key range of ∼ 1600–3200 keV. The results demonstrate a linear dependence of the projectile energy on the terminal voltage.