Writing 10 Gb/s Data Bits With Addressing Using External Cavity-Based SMFP-LDs

2019

Closed access Metadata (CSL-JSON)
DOI 10.1109/jstqe.2019.2911854
Data confidence 70 medium
How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

Memory accessing is one of the challenging issues for utilizing the improvements in processor speed. Due to the rapid enhancement on processor speed compared to the memory accessing technique, the gap between the memory accessing and processor speed is rapidly widening. Hence, a new technique to address this issue needs to be devised. In this paper, we experimentally demonstrate the complete scheme of wavelength division multiplexing enabled memory write operation in the desired memory location using single mode Fabry-Pérot laser diodes (SMFP-LDs). For a proof of concept, we demonstrate writing a stream of data bits at 10 Gb/s data rate in a memory unit that consists of four single bit set-reset (SR) latches with a unique address. The input data bits are stored in the respective latch of the memory bank in accordance with the address bit set along with a write instruction. A higher order of memory units with address decoding can be realized by increasing the higher order of decoder and the memory units. The observed optical domain waveforms at the respective nodes of each block, eye diagram, SNR, and bit error rate (BER) prove the verification of writing input data to the desired memory locations using SMFP-LDs. We observed an extinction ratio of more than 12 dB, no noise floor at the BER of 10-12, and a maximum power penalty of about 2.5 dB in the proposed scheme.