Modelling and efficiency assessment of vertically reinforced slab foundation of multi-storey building

K.T. Alenov, Yerik T. Bessimbayev, Kylyshbay Bissenov, А.S. Shadkam, S.Е. Niyetbay, Zhangazy N. Moldamuratov

Nanotechnologies in Construction A Scientific Internet-Journal, 2025

Full text Open access: Gold Metadata (CSL-JSON)
DOI 10.15828/2075-8545-2025-17-2-151-172
Data confidence 70 medium
How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

Introduction.The aim of this study is to investigate the structural behavior and effectiveness of slab foundations reinforced with vertical elements, a technique increasingly employed in civil engineering to improve the performance of foundations on weak, compressible soil.Traditional slab foundations often suffer from excessive settlement and low bearing capacity, especially under high loads from multi-storey buildings.Reinforcement of the soil base provides a viable solution to these challenges by improving stiffness and reducing deformation.Methods and Materials.The study is based on numerical modeling using the finite element method (FEM) in PLAXIS 3D software, applying the Hardening Soil model in accordance with Eurocode 7. A 9-storey building with a monolithic slab foundation was modeled, and different configurations of vertical reinforcing elements were analyzed.The key parameters varied in the simulations included the spacing (2×2 m, 3×3 m, and 5×5 m) and length (2.5 m, 5.5 m, and 9.5 m) of reinforcing elements.Soil properties were derived from site-specific geotechnical investigations.Results and Discussion.The analysis showed that reinforcing the slab foundation significantly reduced deformation (by a factor of three) and bending moments (by up to 60%) compared to the unreinforced case.The most efficient configuration was found to be concrete elements of 9.5 m length with 2×2 m spacing.The use of vertical reinforcement not only increased the bearing capacity of the foundation but also optimized the stress distribution within the soil mass, minimizing differential settlement.Conclusion.Vertically reinforced slab foundations provide a reliable and cost-effective solution for construction on weak soils.The study confirms that optimal design of reinforcing elements -particularly their length and spacing -plays a crucial role in improving foundation performance.These findings can be directly applied to enhance the design and safety of multi-storey building foundations under challenging geotechnical conditions.