Abstract
The article presents factors influencing the germination and development of plants after seeding with disk seeders. Schemes of improved two-disk seeders are proposed, forces acting on the improved seeder during operation, determination of the maximum distance between the seeder disks at the field surface level, and calculation schemes for determining the draft resistance of the serial and improved seeders, the area of the flat disk segment of the seeder, determination of the deformer, and tailstock area of the pressing plate. During the theoretical study of the seeding process, the following parameters and observations were obtained: analytical dependencies of soil density created by the pressing plate; geometric parameters of the pressing plate with a curvature radius r = 52…57 mm, plate section thickness of 2.5 mm; installation of the pressing plate insignificantly increases the draft resistance of the seeder; and the depth of the seeder’s travel has the greatest influence on spring deformation. Experimental studies reveal that the stiffness of the pressing plate is 7500…7600 N/m, ensuring an optimal furrow bottom density of 1.1–1.3 g/cm3; in the range of seed embedding depth of 0.05…0.07 m, 89% of the total number of seeds are placed compared to 76% of seeds embedded by the serial seeder.