Abstract
This study is focused on the sorption properties and the changes in the structure and state of Ti-25Al-25Nb (at.%) system alloys under thermal cyclic loading. These samples were produced by combining high-energy processing methods through mechanization and spark plasma sintering in the temperature range of 1100–1300 °C, followed by two-stage heat treatment at temperatures of 800 °C and 1250 °C. Thermal cyclic experiments on hydrogen sorption/desorption with samples of the Ti-25Al-25Nb (at.%) system were conducted at the VIKA experimental installation at a saturation temperature of about 500 °C and a degassing temperature of 610 °C. It took about 41 min to reach pressure equilibrium at 500 °C. The hydrogen diffusion coefficient was calculated based on the Barrer formula and was 9.1 × 10−5 cm2/s at 500 °C. The maximum hydrogen content was recorded after the first sorption/desorption cycle and was 1.91 wt%. Due to the multiple thermal cyclic effects in the hydrogen medium, the predominantly two-phase (O + B2) alloy structure underwent transformation to form a new structure (O-AlNbTi2). In the phase composition of the Ti-25Al-25Nb (at.%) alloy, the formation of hydrides in the form of independent phases as a result of thermal cycling was not detected. Hydrogen absorption is most likely to be associated with the formation of an interstitial solution based on existing crystalline phases.