Study on the effectiveness of a solar cell with a holographic concentrator

N.S. Buktukov, Konstantin A. Vassin, Gulnaz Zh. Moldabayeva

2023

Full text Open access: Hybrid Metadata (CSL-JSON)
DOI 10.1515/ehs-2022-0106
Data confidence 70 medium
How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

Abstract Solar energy is an important power source. Given this, the development in the direction of converting solar radiation into electrical energy using holographic concentrators is of great importance. The purpose of the study is to determine the electrical characteristics of the solar cell inside the solar cells. To determine the electrical characteristics of the solar cell inside the photovoltaic panel, digital sensors HC-SR04, INA219 and the “Arduino Nano” microprocessor controller were used. The paper presents the results of experimental studies of a solar panel with a holographic concentrator and photovoltaic cells based on gallium arsenide. The high efficiency of converting solar energy into electrical power is shown when dispersing and focusing different wavelengths on a photocell. During elaboration of the obtained volt-ampere characteristics of solar photovoltaic conversion elements, which determine the output power of the photovoltaic panel, the high potential of the developed design of the photovoltaic panel has been revealed. The practical value of the study lies in the fact that with the help of a holographic concentrator it is possible to increase the efficiency of solar energy conversion.