Abstract
The purpose of this study was to optimize the processes of wetting fillers by varying the content of such additives as a surfactant and polymer in bitumen–mineral compositions in order to achieve optimal performance. The cosine of the contact angle was used as a criterion for assessing the adhesion of the bitumen binder to the surface of crushed stone. The effect of the additives’ concentration on surface tension and adhesive efficiency in binary and ternary bitumen compositions was studied. The following chemicals were used as additives: the original product AS-1, industrial additive AMDOR-10, and used sealant AG-4I, a product based on polyisobutylene and petroleum oils. AS-1 was obtained from the oil refining waste in the laboratory of M. Kozybayev North Kazakhstan University. The ternary “bitumen–AG-4I–AS-1” composition provided a maximum decrease in the contact angle by 15.96° (gray crushed stone) and by 14.06° (red crushed stone) relative to original bitumen, providing better wettability of the mineral filler particles with the bitumen, and as a result, maximum adhesion between the bitumen and crushed stone. The optimal performance of the bitumen–mineral composition was recorded with the joint presence of additives in the bitumen: AS-1 at a level of 1.0 g/dm3 and AG-4I at a level of 1.0 g/dm3.