Selective oxidation of methane into synthesis gas at short contact times on low-loading platinum-ruthenium catalysts

K. D. Dosumov, Н. М. Попова, Tolkyn S. Baizhumanova, Svetlana A. Tungatarova

2010

Closed access Metadata (CSL-JSON)
DOI 10.1134/s0965544110060083
Data confidence 85 high
How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

The results of the study of Pt-Ru/2% Ce/(θ + α)-Al 2 O 3 catalysts with various Pt/Ru ratios used in the process of selective methane oxidation into synthesis gas at short contact times are presented. The optimal catalyst preparation conditions have been found for the process. It has been revealed that the methane conversion at 1173 K and a contact time of 4.0-3.0 ms varies from 96 to 100% and the selectivities for hydrogen and CO are 100 and 95–100%, respectively. At a Pt: Ru molar ratio of 2: 1 or 1: 1 and τ = 3.5 ms, the maximum (100%) degree of the conversion of methane into synthesis gas via the direct route is observed; the selectivity for H 2 and CO is 100%, and the total content of the noble metals is O ≥ 0.2%.