Development and computer simulation of a new technology for forming and strengthening screw fittings

Sergey Nikolaevich Lezhnev, Evgeniy Panin, Andrey O. Tolkushkin, Dmitry V. Kuis, А. В. Касперович

2023

Data confidence 85 high

How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

The paper presents the results of computer simulation of a new technology for forming and strengthening screw fittings, carried out using the planned experiment.The purpose of the simulation was to determine the parameters at which the deformation process is stable.The friction coefficient in the rolls, the distance of the matrix from the forming rolls and the initial diameter of the workpiece were selected as variable factors.The workpiece speed was considered as the main parameter and the model was considered unsuccessful if the front end of the workpiece had a zero value of speed (the workpiece was stuck).It was found that all three parameters have a significant impact on the process stability.The best parameters are an increase in the friction coefficient in the rolls and the initial diameter of the workpiece (or absolute compression in the rolls) and a decrease in the distance of the matrix from the forming rolls.Also, a rational factor that has a beneficial effect on the process is the reduction of backpressure from the matrix, which can be realized by reducing its length.