Study of the Effect of Fluxing Ability of Flux Ores on Minimizing of Copper Losses with Slags during Copper Concentrate Smelting

Maral Dyussebekova, Bagdaulet Kenzhaliyev, Sergey Kvyatkovskiy, Sultanbek Kozhakhmetov, Anastasiya Semenova, Bulat Sukurov

Metals, 2022

Full text Open access: Gold Metadata (CSL-JSON)

DOI 10.3390/met12081240

Data confidence 70 medium

How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

The article describes the effect of the fluxing ability (FA) of ores used as a flux on slag formation and copper losses. In Kazakhstan, at the Balkhash copper smelting plant (BCSP), currently used fluxes have a very low SiO2 content—about 62%—whereas the Al2O3 content is 12%. Its fluxing ability (FA) was estimated, and it was shown that currently used silica fluxes have an exceedingly low FA. Only half of the fluxes participate in the slag formation. To obtain slags with a low magnetite concentration, a considerable surplus of flux must be added, which will result in a sharp reduction in its melt temperature, increased slag output, and therefore copper losses. The slag structure was studied by means of scanning electron microscopy and electron probe microanalysis (EPMA). To determine one of the primary causes of flux ores’ low FA, it is necessary to use the microstructural pattern of experimental samples.