Melt–Vapor Phase Transition in the Aluminum–Selenium System in Vacuum

2023

Full text Open access: Gold Metadata (CSL-JSON)
DOI 10.3390/met13071297
Data confidence 70 medium
How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

The boundaries of liquid and vapor coexistence fields at pressures of 101.3 and 0.133 kPa were calculated based on the partial vapor pressure values of the components in the Al-Al2Se3 and Al2Se3-Se partial systems. The vapor pressures of the more volatile aluminum selenide and selenium in the above systems were determined by the isothermal version of the boiling-point method. The partial pressures of the fewer volatile components were determined by numerical integration of the Gibbs–Duhem equation. The partial and integral values of the thermodynamic functions of the formation and evaporation of solutions were calculated based on the values of the partial vapor pressure of the system components. Based on the analysis of the complete phase diagram, it was found that the purification of aluminum by vacuum distillation in a single operation can remove aluminum selenide and selenium at an appropriate rate. The distillation of selenium from melts in vacuum in the whole concentration range of the Al2Se3-Se system will proceed from the mixture of the solution with Al2Se3 cryst., with accumulation of the latter in the distillation residue.