Modeling Arc Spraying Process for Eccentric Sleeve of Cone Crusher GP 500 Using Computer-Aided Design

Saulekul Aizhambaeva, Gulnara Santayevna Zhetessova, Tatyana Nikonova, Galina Vasilevna Vavilova, Michael Belik

2019

Full text Open access: Hybrid Metadata (CSL-JSON)

DOI 10.4028/www.scientific.net/msf.970.343

Data confidence 85 high

How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

This article deals with studying the technology of electric arc spraying of the eccentric body by selection of the copper-steel pseudo-alloy for spraying a covering. The part durability with the placed covering depends on the technology of spraying and the properties of the sprayed material. By increasing the strength of adhesion of the covering to the base it is possible to establish the optimal indicators of the coating mode. It became the main criterion of studying the arc spraying technology from the mathematical point of view.