The Formation of Modified Layers at High-Speed Steels after Electrolytic-Plasma Nitriding

Маzhyn Skakov, Bauyrzhan K. Rakhadilov, Erlan G. Batyrbekov

2014

Closed access Metadata (CSL-JSON)
DOI 10.4028/www.scientific.net/amm.682.104
Data confidence 70 medium
How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

In the article the formation peculiarities of the modified layer at R9, R6M5 R18 high-speed steels (HSS) after electrolytic-plasma nitriding are shown. It is established that in the result of electrolytic-plasma nitriding on the of high-speed steels samples surfaces formed modified layers with higher hardness. Hardness of HSS increased to 11.9-12.8 HPa after electrolytic-plasma nitriding, mainly depends to the formation of a diffusion layer of nitrogen martensite with Fe4N (γ’-phase) monophasic nitride. It is determined that a modified layer consists of nitrogenous martensite with Fe4N monophasic nitride. Perspectivity of use an electrolytic-plasma nitriding method to improve performance cutting tools made of high speed steels is shown.