Investigation of Wear of Cutting Part of Polygonal Knife Car Graders in Different Ground Conditions

Rustem Kozbagarov, Marzhana Amanova, Nurbol Kamzanov, Lalita Bimagambetova, Aizhan Imangaliyeva

2022

Full text Open access: Gold Metadata (CSL-JSON)

DOI 10.26552/com.c.2022.4.d229-d238

Data confidence 70 medium

How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

The wear of cutting elements of auto graders allowed in practice causes an increase in the cutting force by 3 to 4 times, the energy intensity of the cutting process by 1.4 to 3 times, the cost of soil development by 8 to 15 % with a decrease in productivity by 10 to 30 %. This increases the stress state of the entire machine and reduces its operational reliability. Excessive wear of cutting elements leads to economic inexpediency or practical impossibility of further operation of machines.