Abstract
Abstract One of the current trends in the complex processing of fine dust from copper smelters is their direct leaching with sulfuric acid. As practical results show, high reliable technological parameters are not achieved due to the high content of arsenic in dust. During sulfuric acid leaching of dust, arsenic is distributed between the lead cake and the solution at a ratio of 40 and 60%, respectively. The redistribution of arsenic between leaching products significantly reduces the technological performance and leads to the accumulation of arsenic in the technological scheme. The paper presents the results of comprehensive studies of the elemental and phase composition of fine dust from one of the copper smelters in Kazakhstan. In the initial dust, along with the main phases presented in the form of lead and zinc sulfate, the following typical components were found: oxides of copper, lead, zinc and copper and zinc ferrites. Arsenic is found in two forms—As(III) and As(V). The laboratory installation and technique for conducting reduction roasting of dust with natural gas are presented. The influence of roasting duration, temperature and natural gas consumption on the extraction of arsenic from dust was studied. It has been established that almost complete, up to 99%, extraction of arsenic from dust is achieved with optimal technological roasting parameters: duration τ = 40 min.; natural gas consumption is 1.5 times higher than the stoichiometrically required amount for the reduction of As 2 O 5 , and temperature 500 °C.