Simulations of Currents in Conditions of Electrical Damage in the Windings of a Single-Phase Furnace Transformer with a Split Secondary Winding

Aleksandr Novozhilov, Т. А. Новожилов, Dilara Rakhimberdinova

2020

Closed access Metadata (CSL-JSON)
DOI 10.3103/s1068371220060073
Data confidence 70 medium
How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

Abstract A mathematical model is suggested to simulate currents under conditions of electrical damage in the windings of a single-phase furnace transformer with a split secondary winding. A method to reduce the number of equations in this mathematical model with many splits has been developed, which allows one to use iterative methods, e.g., the Gauss method, to determine currents in the windings. The effectiveness of the obtained model has been experimentally verified. It has been shown that the error in modeling the currents in the windings of a single-phase furnace transformer with secondary winding splitting during a short circuit in the primary winding does not exceed 10–15%. On the basis of the method to reduce the number of equations in a mathematical model, mathematical models have been developed; they allow one to simulate the currents in the windings of a furnace transformer during the short circuit in a short network with the break in a splitting conductor and under the normal load mode.