Abstract
This study presents a comparative investigation of the microstructure, phase composition, microhardness, tribological behavior, and corrosion resistance of heterogeneous coatings deposited on St3 steel by twin-wire electric arc spraying (TWEAS). Three wire combinations were examined: ER309LSi + Steel 70, Sv-08G2S + Steel 70, and 30KhGSA + ER309LSi. The coatings were characterized using X-ray diffraction (XRD), scanning electron microscopy with energy-dispersive spectroscopy (SEM/EDS), Vickers microhardness testing, ball-on-disc tribological measurements, and potentiodynamic polarization in 3.5 wt.% NaCl solution. All coatings exhibited a characteristic lamellar structure with a thickness of 340–360 μm and hardness values significantly higher than those of the steel substrate. The 30KhGSA + ER309LSi coating demonstrated the highest cross-sectional microhardness (532 ± 13 HV) and the lowest specific wear rate (0.411 × 10−4 mm3/(N·m)), which was more than five times lower than that of the substrate. The enhanced wear resistance was associated with the formation of the Cr7C3 and Cr23C6 carbide phases, as identified by XRD. The Sv-08G2S + Steel 70 coating exhibited the lowest corrosion rate among the investigated coatings due to its more homogeneous ferritic structure and reduced electrochemical contrast between lamellae. The results demonstrate that the phase composition and distribution of alloying elements play a decisive role in determining the functional properties of heterogeneous TWEAS coatings.