SURFACE HARDENING AND STRUCTURAL-PHASE STATE OF STAINLESS AUSTENITIC STEELS 12Х18Н10Т AND 08Х18Н9 AFTER HEAT TREATMENT AND SPRAYING OF A COATING

A. M. Urykkaliev, D. Erbolatuly, Gulnara Yerbolatova, А. В. Градобоев, Dastan Buitkenov

2026

Full text Open access: Hybrid Metadata (CSL-JSON)

DOI 10.52676/1729-7885-2026-1-207-217

Data confidence 70 medium

How this score is calculated

It is built from checkable properties of the record itself: whether the article has a DOI, how many independent sources confirmed its data, whether the required fields are filled in, and how recent the latest confirmation is. Disagreement between sources and a missing identifier lower it. A value of 80 or above means the record was published without further checking; 60 to 79 means it is published at reduced confidence, with a manual check advisable. A record verified by an editor by hand is never pushed below 90 by a recalculation. This scores our data about the article, not the article itself.

Abstract

The features of the structural-phase state and changes in the surface properties of stainless steels 12Kh18N10T and 08Kh18N9 after heat treatment, rolling, and coating deposition have been investigated. The application of a treatment method involving aluminum spraying followed by annealing at 700 ℃ (1 h) with slow heating (250 ℃/h) to the target temperature made it possible to significantly increase the microhardness and wear resistance of the surface of 12Kh18N10T steel. The substantial improvement in microhardness and wear resistance after such treatment is attributed to the formation of a new ordered Fe₃Al phase with an FCC lattice.