Influence of Hydrothermal Treatment Conditions on the Formation of Lanthanum Orthophosphate Nanoparticles of Monazite Structure

2020

Закрытый доступ Метаданные (CSL-JSON)
DOI 10.1134/s1070427220040084
Достоверность данных 85 высокая
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

Abstract The inluence of the heat treatment conditions and of the time of hydrothermal treatment at 210°С on the phase composition and size of crystallites and nanoparticles of lanthanum orthophosphate (LaPO4) was considered. The heating conditions in the course of hydrothermal synthesis of LaPO4 influence the structural transition of lanthanum orthophosphate of rhabdophane structure into the phase of monazite structure, and also the particle morphology and crystallite size. The phase of monazite structure with the crystallite size of approximately 12 nm without rhabdophane impurity is formed after hydrothermal treatment at 210°С for 30 min in the case of microwave heating of the hydrothermal fluid. When using external heating of autoclaves, at the same temperature inside the autoclave, the mean size of the crystallites of the monazite phase formed is 17 nm.