Slot-Dependent Wireless Power Transfer System for MBAN Applications

2020

Закрытый доступ Метаданные (CSL-JSON)
DOI 10.1109/icce-berlin50680.2020.9352185
Достоверность данных 85 высокая
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

This paper presents for the first time the wireless power transfer (WPT) system that is fully dependent on the etched slot on the ground plane. At first, the defected ground structure-based resonator with the circuit area of 20-by-20 sq. mm and a rectangular defect was proposed. Then, it was changed to three rectangular slots to achieve resonance at the desired frequency. Subsequently, the resonators with optimized parameters were aptly utilized to design the WPT system that works at 2.4 GHz. The operating frequency complies with the practical medical body area network band and, therefore, can be employed to the biomedical implants. It has been demonstrated that the perfect coupling can be observed at a distance of 10 mm. As a consequence, at this distance the obtained simulation results of WPT show 67% efficiency and the figure of merit of 0.335.