EXPERIENCE OF APPLYING SHOT-TERM INTERMEDIATE ANNEALS IN BACK-PRESSURE EQUAL-CHANNEL ANGULAR PRESSING OF ALUMINUM ALLOYS

2019

Полный текст Открытый доступ: Gold Метаданные (CSL-JSON)
DOI 10.17804/2410-9908.2019.1.043-054
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

The influence of severe plastic deformation on hypoeutectic silumin is studied.A positive effect of equal-channel angular pressing with back pressure on the mechanical properties of the AL9 alloy of the Al-Si-Mn-Fe system has been found experimentally.The evolution of the microstructure in the process of deformation is estimated.The effect of short-term intermediate anneals on the microstructure, mechanical properties and ultimate plasticity of the alloy is studied.As a result of additional annealing, significant microstructural changes do not succeed, but the coagulation of excess phases proceeds very intensively, which causes a 20 % increase in strength after the second deformation cycle.Fractographic studies demonstrate the presence of coagulated particles on the samples deformed with the use of short-term intermediate anneals.Limiting plasticity also rises to 0.2 as compared to 0.12 for the samples treated with only ECAP-BP.