MODIFICATION OF COATINGS BASED ON Al2O3 WITH CONCENTRATED ENERGY FLOWS

2021

Закрытый доступ Метаданные (CSL-JSON)
DOI 10.32014/2021.2518-170x.72
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

This paper presents the study results of structural-phase composition and mechano-tribological properties of Al2O3 coatings after exposure of concentrated energy flows. Revealed that the treated coatings are generally characterized by high microhardness compared to the initial coating. Determined that after treatment with detonation and air-plasma action is observed an increase in the intensity of α-Al2O3 reflexes. Established that the increasing hardness of detonation coatings is associated with an increasing density of the material and the recovery of the α-phase Al2O3 in the composition of the protective layer under the influence of thermal activation of the surface. Determined that after treatment with detonation and plasma exposure is observed an increase in the intensity of reflexes α-Al2O3. Established that the treatment with detonation and air-plasma action leads to a decrease in the friction coefficient. The obtained data indicate that the tribological characteristics of coating based on aluminium oxide can be improved by exposure to concentrated energy flows. Established that coatings treated with plasma action showed high tribological properties.