Assessment of the Suitability and Accuracy of Different Methods to Determine the Degree of Photodegradation of High- and Low-Density Polyethylene, Polypropylene, Polyvinyl Chloride, Nylon and Polystyrene Microplastics

Microplastics, 2026

Полный текст Открытый доступ: Gold Метаданные (CSL-JSON)
DOI 10.3390/microplastics5020062
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

In an accelerated aging experiment involving a wide range of cumulative UV-B radiant exposures (up to approximately 9.46 × 103 J cm−2), the degradation state of microplastics was assessed using SEM, FTIR, Raman spectroscopy, and DSC, and correlated with the cumulative UV-B dose. Sunlight-induced photooxidation is a significant weathering mechanism for microplastics. In this study, high-density polyethylene (HDPE), low-density polyethylene (LDPE), polypropylene (PP), polyvinyl chloride (PVC), nylon, and polystyrene (PS) were exposed to UV-B radiation under controlled dry conditions at two irradiance levels (0.06 and 0.6 mW cm−2), covering cumulative UV-B radiant exposures of up to approximately 9.47 × 103 J cm−2. Degradation was evaluated using SEM, FTIR, Raman spectroscopy, and DSC, and was related to the cumulative UV-B dose (H). The extent and progression of degradation varied significantly among the polymers. Overall, FTIR provided the most sensitive assessment of photooxidative surface changes for HDPE, LDPE, PP, and PS, Raman spectroscopy was most diagnostic for PVC (particularly for dechlorination-related changes), and DSC-derived crystallinity was most informative for nylon. These dose-resolved datasets establish a reproducible reference framework (“degradation library”) to facilitate the comparative assessment of the relative photooxidative aging stage of microplastics under comparable surface UV-driven conditions. Outdoor “sunlight-equivalent” times are reported solely as order-of-magnitude contextualization due to environmental variability.