Electrodeposition of Copper Selenide onto Mo Electrode in Tartaric Acid Solution

2018

Закрытый доступ Метаданные (CSL-JSON)
DOI 10.1134/s1070427218050087
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

Results are presented of a study of the electrochemical behavior of copper(II) and selenium(IV) ions and their joint reduction on a molybdenum electrode by cyclic voltammetry in a tartaric acid electrolyte. The potentiostatic deposition was used to obtain copper selenide deposits on Mo plates. The diffraction and energydispersive analyses demonstrated that a Cu 2‒ x Se compound is formed with an admixture of the CuSe phase. A suggestion is made that the process of underpotential reduction affects the formation of copper selenide. Copper selenide films were deposited at a potential of ‒0.6 V in the course of 30 min with a thickness of 0.43 μm and high adhesion to the substrate. At potentials in this range, an additional amount of the deposit may be formed due to the chemical reaction between Cu + and Se 2‒ ions. The p-type conduction was determined for films electrodeposited at various potentials.