Determination of the Magnetic Field Induction Around Compact Bus Ducts for the Design of Current Protection

2026

Закрытый доступ Метаданные (CSL-JSON)
DOI 10.52209/1609-1825_2026_2_398
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

The aim of this study is to assess the influence of currents in one of two adjacent bus ducts on the electromotive force at the terminals of inductive coils mounted outside the enclosure of the second bus duct. The research methodology is described. The paper presents the results of computer modeling of magnetic fields around two bus ducts, installed side by side and rated for 10 kV, as produced by industry. Coefficients and a formula based on the Biot – Savart – Laplace law are provided, enabling the calculation of the total magnetic field induction at the location of the inductive coils, taking into account the influence of currents in the neighboring bus duct. It is shown that the greatest effect on the inductive coils is exerted by the current in the enclosure of the adjacent bus duct, which occurs during double earth faults. It has been established that, for the design of current protection systems, it is advisable to install the inductive coils opposite the busbars located farthest from the neighboring bus duct