Irradiation experiments with Li2TiO3/Li4SiO4 two-phase lithium ceramics at the WWR-K reactor

2025

Полный текст Открытый доступ: Gold Метаданные (CSL-JSON)
DOI 10.26577/rcph202592110
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

Advanced two-phase lithium ceramics Li2TiO3-Li4SiO4 are considered as a potential candidate for use in solid-state fusion reactor blankets. This phase composition makes it possible to combine the high lithium content in orthosilicate Li4SiO4 with the mechanical strength of lithium metatitanate Li2TiO3. The study of the effect of neutron irradiation on two-phase lithium ceramics, as well as the correlation with its structural and physical properties, remains quite relevant, taking into account the technological diversity in the manufacture of the ceramics themselves and ceramic pebbles. This paper presents the results of an experiment on reactor irradiation of two-phase ceramics 25mol% Li2TiO3 + 75mol% Li4SiO4 obtained on the KALOS installation (KArlsruhe Lithium OrthoSilicate) using a modified melt-spraying technique. Neutron irradiation was carried out at the WWR-K research reactor (Almaty, Kazakhstan) for 21 days at a sample temperature of 50 °C. The accumulated fluence for thermal neutrons was 3.7·1019 n/cm2. The nuclear reaction rate was 2.16·1013 reactions/cm3⋅s; the damage rate was 7.63·10-8 dpa/s, the damage during the irradiation period was 0.14 dpa.