Identification of the effect of electric pulse discharges on the recycling of household glass

2024

Полный текст Открытый доступ: Gold Метаданные (CSL-JSON)
DOI 10.15587/1729-4061.2024.296855
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

The work was devoted to the study of the recycling of household glass waste by the electric pulse method. Cullet and glass containers were considered as the object of research. Cullet and used glass containers are considered suitable for recycling among solid household waste. The treatment of solid household waste was carried out with the formation of electrical discharges in an inhomogeneous environment (glass fragments and glass products in an aqueous environment). The experiments were carried out at different values of pulse discharge voltage (from 12 kV to 37 kV), capacitor bank capacity (from 0.4 to 1.2 µF), number of pulse discharges (from 250 to 1,000) and frequency (from 0.3 Hz to 2 Hz). The dependence of the output of the finished product on the parameters of electric pulse discharges has been revealed from the research results. According to the main results of the research work, it was found that as the parameters of electric pulse discharges increase, the yield of the finished product increases. The data made it possible to assign effective parameters for processing cullet and glass products using the electric pulse method. The granulometric composition of the powder material obtained by this method has been determined. A product with a diameter of the largest fraction of 5-8 mm and a diameter of a small fraction of 0.4 mm and 0.7 mm was obtained. The results of the experiment can be used in research on saving natural resources, energy conservation and solving environmental problems of solid waste recycling. Powdered glass is used as a thermal insulator and decorative material in construction. In addition, crushed glass is used in the production of concrete as an additional raw material.