Аннотация
This paper presents the results of research aimed at developing the technology of plow share hardening by means of electrofriction hardening. It is shown that in electrofriction hardening of plow shares a structure with microhardness gradient is formed along the depth of the hardened zone. After electrofriction hardening the microhardness of plow share increases in 3–3.5 times in comparison with the initial state. The reason for the gradient character of microhardness distribution along the thickness of the modified layer is the ultra-high cooling rate, which causes a high temperature gradient near the surface. On the basis of the results of scanning electron microscopy it is established that at electrofriction hardening of steel 40Kh the hardened surface layer is formed, consisting of two zones: the surface hardened zone with the structure of fine–needle martensite and austenite; the zone of thermal influence (transition layer) with martensite-perlite structure, smoothly passing into the initial ferrite-perlite structure. It is established that the phase composition of steel 40Kh in the initial state consists of α-Fe phase with BCC lattice, and after electrofriction hardening the hardening phases of residual austenite (γ-Fe) and martensite (α'-Fe) are formed. The obtained data allow us to conclude that electrofriction treatment is an effective method of plow share hardening from structural steel 40Kh.