EVALUATION OF THE PHASE STABILITY, MICROSTRUCTURE, AND DEFECTS IN HIGH-ENTROPY CERAMICS AFTER HIGH-ENERGY ION IMPLANTATION

2022

Закрытый доступ Метаданные (CSL-JSON)
DOI 10.1615/hightempmatproc.2022043733
Достоверность данных 85 высокая
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

The location and distribution of atoms in the crystal lattice play a major role in controlling the mechanical and tribological properties of high-entropy alloy (HEA) ceramic materials. Herein, vacuum arc-deposited (TiZrHfVNb)N coatings have been implanted with 200 MeV xenon (Xe14+) ions at room temperature and fluences of 5×1011, 5×1012 and 5×1013 ions/cm2. The defect structure evolution of Xe-related defects and their effects on the structural, nanomechanical and tribological properties of HEA nitride were characterized. The results show redistribution of lattice atoms and defects. Furthermore, it is found that the decrease of the wear rate in implanted coating (5×1011ions) from 9.7×10-6 to 4.85×10-5 mm3m-1N-1 has resulted from new defect combinations (vacancies, interstitial voids and dislocations). Another source responsible for properties deterioration was the breaking disorder of the elemental composition revealed by mapping the elemental composition by SIMS. These findings enhance the fundamental understanding of the high-energy irradiation effect on HEA ceramics.