Polyamide 6 is an Integral Component of the Protective Coating for Steel ST3

2023

Закрытый доступ Метаданные (CSL-JSON)
DOI 10.52209/2706-977x_2023_2_10
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

In this study, an attempt was made to use PA 6 as a component of an experimental composite anticorrosive coating that increases the adhesion of hydrophobic coatings (iron stearate and zinc stearate) to protect structural steel St3. The phosphating primer leads to the formation of a film of iron salts insoluble in water on the steel surface and adsorption of PA 6 on them. Hydrophobization of the surface formed in this case zinc stearate leads to the formation of a coating with high adhesion and anticorrosive properties. Tannin is a corrosion inhibitor. The advantage of the tannin primer is that its molecules are able to bind to the metal surface and the PA 6 macromolecules simultaneously, forming a strong coating on the metal. Zinc stearate gives the coating hydrophobic properties and additional protection of the metal from corrosion.