Effect of Nickel Nanopowder on the Thermal Degradation of Coal Tar Distillate

2022

Полный текст Открытый доступ: Hybrid Метаданные (CSL-JSON)
DOI 10.31489/2022ch2/2-22-19
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

Regularities of influence of nickel nanopowder on the thermal degradation of coal tar distillate were deter-mined using model-free Kissinger, Flynn-Wall-Ozawa and model-fitting Coats-Redfern methods. Coal tar distillate with a boiling point of <350 °C was obtained by simple distillation of primary coal tar from the Shubarkol deposit. Nickel nanopowder was used as a catalyst and was added to coal tar distillate in a quantity of 1 % of the mass of the distillate and then the process of thermal degradation of coal tar distillate was con-ducted at heating rates 5, 10 and 20 °C/min in an inert gas medium. Nickel powder was obtained by high-voltage discharge impact on the dc electrolysis. X-ray diffraction (XRD) analysis showed that the obtained nickel powder has face-centered cubic structure and the average crystallite size calculated by the Scherrer equation was ~ 34 nm. Calculations of activation energy were performed via processing of thermogravimetric data. The Kissinger method showed that the activation energy value decreases from 145.19 kJ/mol to 43.65 kJ/mol, by the Flynn-Wall-Ozawa (FWO) method the value decreases from 152.82 kJ/mol to 51.65 kJ/mol, and by the Coats-Redfern method the value decreases from 143.38 kJ/mol to 52.64 kJ/mol. Ap-plicability of these methods is ensured by the high values of correlation coefficients.