NUMERICAL STUDY OF THE POLYMER INJECTION ON DISPLACEMENT OF HIGH-VISCOUS OIL FROM CARBONATE FORMATION

2021

Полный текст Открытый доступ: Gold Метаданные (CSL-JSON)
DOI 10.55452/1998-6688-2021-18-3-46-50
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

Residual recoverable reserves of high-viscosity and heavy oils in the Republic of Kazakhstan amount to about 340 million tons. The main oil fields containing high-viscosity and heavy oil are Karazhanbas, Kenkiyak, Zhetybai, North Buzachi, Kenbai, etc. Improving the system for the development of high-viscosity oil fields and the selection of rational EOR is relevant for Kazakhstan, as this will increase the efficiency of their development. Given the high resource potential of such fields, it is necessary to develop and introduce new technologies in the development of high-viscous oil fields using enhanced oil recovery methods. To ensure high oil recovery factors, it is necessary to carefully select the EOR applicable to high-viscosity oil fields at an early stage of their development. This work is devoted to the problem of EOR selection in the development of high-viscosity oil fields. For the research polymer injection was selected. Evaluation of the efficiency of the proposed EOR was carried out based on the results of numerical experiments to displace high-viscosity oil with the creation of reservoir conditions. As a result, the aqueous polymer solution with the concentration of 0.05 % yielded 51% of oil recovery, whereas water injection recovered only 10% of oil. However, the interaction of the polymer with high-viscosity oil has not been deeply studied, which is relevant to the fields of Kazakhstan.