Аннотация
The article discusses the main types of installations (HVOF / HVAF (High Velocity Oxy / Air-Fuel),the Russian analogue of which is HPS/SGV (gas-flame supersonic/supersonic gas-air, activated arcmetallization ADM devices) and the use of high-speed gas-flame technology for surface hardening formachine parts. Here we considered all types of flame treatment (welding, oxyfuel cutting, brazing, surfacehardening, flame straightening, metallization, welding and spraying of non-metals), the performance ofvarious methods of thermal spraying (GTN), and also considered the properties, methods of productionand use of gases used in flame processing, modern equipment and equipment for all considered processes.The main task of the coating obtained by the method of flame spraying is also considered. It is shown thatthe deposition of coatings by the method of high-speed gas-flame spraying and effective materials forprotection is promising. In addition, safety precautions for gas-flame processing are considered. The stateis analyzed that the abrasive wear resistance of steel is a structurally sensitive characteristic, therefore, aneffective wear-resistant material must have the ability to harden under the influence of working loads, duringoperation, and from this, materials are effective materials for protection under abrasive wear; correspondingto the principle of metastable austenite. The characteristics of a heterophase jet obtained under optimalspraying modes are estimated on the basis of a calculation using a mathematical model of a two-phase flow. Key words: thermal spraying, electroplating, flame technology, corrosion, robots of automatic gas – flamespraying.